![]() Set no reboot, set Baudrate(have literally tried ALL baudrates) Select CC3D as the target and choose the latest revision CC3D Starts with only one solid green LED(normally flashing blue led not illuminated) Jump Bootloader pins(have tried with wire, solder, screwdriver) Com Port of FTDI shows in the COM port combobox Open Cleanflight/iNav(^^^^I have tried switching the order of these steps with not effect) Connect FTDI to PC(I have tried switching the order of these steps with not effect) Connect FTDI to CC3D Main port( only RX/TX/GND no power) I have also never seen the CC3D register as a COM port, ive only seen it register as the malfunctioned device in the USB root A report from windows pops up that the USB device has malfunctioned. Connect CC3D into PC (I have tried this with the board powered externally as well as only through the USB) Disconnect CC3D(and disconnect external power for complete power down) Connect CC3D to PC (I have tried this with the board powered externally as well as only through the USB) I will describe my experience with the two methods below. At this point I'm hoping someone can provide some further knowledge on what could be going on here. I have tried the methods with and without the FTDI adaptor with no success. After trying every tutorial I could find I am unable to get Cleanflight or iNav on my CC3D. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |